When
traffic sign faces the backlighting condition, due to extremely strong
backlighting, the illumination behinds the sign and the information of sign itself
presents very weak illumination results in the high contrast brightness of light
intensity and then, leading the road users unable to identify the information showed
on the sign, causing the road users unable to be prepared, to deal with the
critical and dangerous traffic conditions in advance, such as Emergency
Steering, Accidents Ahead, Road Maintenance Ahead, etc--- Any Dangerous Driving
Conditions.
In order to solve above
stated traffic sign with backlighting problem, our company developed a No electro-Optical
Studs, through the refractive principle of curved surface on Optical Stud that could transmitting the light
from the rear side to the front side of sign, meanwhile maintaining a very high
optical efficiency that could illuminating the light to road users directly, therefore road users could
read the information from the sign clearly even under the circumstances of backlighting.
To meet
the requirements of traffic sign that needs to be higher than drivers, optical
studs could refracting light to be approx. down (to the ground), deviate from
the optical axis about 10 degrees and presenting the divergent angle about 20
degrees, refer to below Picture A:
As seen from the top view, the projection of light through the optical studs, from the left to right direction, the visual range is approximately plus and minus 20 degrees, refer to below Picture B:
When a
traffic sign is 100 meters away from the road users, the visible range of
information showed on the sign is covering about 72.79 meters in width and
within this coverage, the information on the sign could be seen entirely and
precisely.
沒有留言:
張貼留言